top of page

Digilent

PYNQ-Z1

Python Productivity for Zynq-7000 ARM/FPGA SoC

  • SoC Features:

    • ZYNQ XC7Z020-1CLG400C

    • 650MHz dual-core Cortex-A9 processor

    • DDR3 memory controller with 8 DMA channels and 4 high performance AXI3 slave ports

    • High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO

    • Low-bandwidth peripheral controller: SPI, UART, CAN, I2C

    • Programmable from JTAG, Quad-SPI flash, and microSD card

    • Programmable logic equivalent to Artix-7 FPGA

      • 13,300 logic slices, each with four 6-input LUTs and 8 flip-flops

      • 630 KB of fast block RAM

      • 4 clock management tiles, each with a phase-locked loop (PLL) and mixed-mode clock manager (MMCM)

      • 220 DSP slices

      • On-chip analog-to-digital converter (XADC)

  • Memory:

    • 512MB DDR3 with 16-bit bus @ 1050Mbps

    • 16MB Quad-SPI Flash with factory programmed globally unique identifier (48-bit EUI-48/64™ compatible).

    • MicroSD slot

  • Power:

    • Powered from USB or any 7V-15V source (see recommended products)

  • USB and Ethernet:

    • USB-JTAG Programming circuitry

    • USB-UART bridge

    • USB OTG PHY (supports host only)

    • Gigabit Ethernet PHY

  • Audio and Video:

    • Electret microphone with pulse density modulated (PDM) output

    • 3.5mm mono audio output jack, pulse-width modulated (PWM) format

    • HDMI sink port (input)

    • HDMI source port (output)

  • Switches, push-buttons, and LEDs:

    • 4 push-buttons

    • 2 slide switches

    • 4 LEDs

    • 2 RGB LEDs

  • Expansion Connectors:

    • Two standard Pmod ports

      • 16 Total FPGA I/O

    • Arduino/chipKIT Shield connector

      • 49 Total FPGA I/O

      • 6 Single-ended 0-3.3V Analog inputs to XADC

      • 4 Differential 0-1.0V Analog inputs to XADC


Product Compliance: 

  • HTC: 8471500150

  • ECCN: 5A992.c

bottom of page