top of page

Fiber Optic Tester

Optical Power Meter

OPM C-Series, -50 to +26dBm

OPM C-Series, -70 to +10dBm

Multifunctional Power Meter, -50 to +26dBm

Multifunctional Power Meter, -70 to +6dBm

Mini Optical Power Meter

Optical Light Source

OLS, SM, 1310/1490/1550/1625

OLS, SM/MM, 850/1300/1310/1550

OLS, SM, 1310/1490/1550nm

OLS, SM, 1310/1550nm, -5dBm±0.5dB

FO Installer Package

Fiber Optic Installer Package

BASIC Installer Package

ADVANCE Installer Package

EXPERT Installer Package

Optical Loss Test Set

OLTS, LS 1310/1490/1550nm, -4dBm

PH300 Series OTDR 1310/1550 (26/24dB)

SmartOTDR, 1310/1550nm

Visual Light Source

PH Visual Fault Locator, 10mW, ~12km

Fiber Identifier

PH Optical Fiber Identifier

PH Fiber Launcher, G657A1, 1000m

Fusion Splicer & Consumable

Training & Development Board

Asset & Data Management

Copper,DSL,WiFi&Broadband Test

Copper Certification

Bit Error Rate (BER)

Asset & Data Management

Ethernet Test - Enterprise

Ethernet Test - Service Providers

Multi-Protocol Field Test

5G Installation & Maintenance Tools

Asset & Data Management

Antenna Alignment & Monitoring

RF Instrumentation

RF Spectrum Analyzers

Fiber Inspection & Cleaning

Dispersion Analyser

Asset & Data Management

Fiber Certification Tier 1

Fiber Certification Tier 2

Fiber Identifiers

Fiber Monitoring

Fiber Optic Sensors

MPO Test Equipment

OTDR & Software

Optical Power Meters

Optical Multimeter

Optical Loss Test Set

Optical Spectrum Analyzers

Kumpulan Abex Sdn Bhd

Always Committed

Multilane

ML4062-ALB-112

Active Loopbacks

Contact Our Expert

Enables the comprehensive equalization techniques required at 800G with the implementation of our new range Active Loopback modules. ML4062-ALB-112 QSFP-DD800 Active Loopback provides instrument-grade measurements directly in port and can retime and equalize port signals to test lossy channels.

QSFP-DD MSA Form Factor
MSA Compatible Configuration and EEPROM
Programmable MSA memory pages
Custom memory maps
I2C Interface
DSP-based architecture
Test modules can be fitted with USB-C port for remote control/automation
Module management supported via standard plug-side I2C CMIS or nose-side USB-C
Static IP Protocol: communication via USBC or RJ45 Ethernet
Embedded electrical DSP chip
Three independent power heaters, dissipating up to 19.2 W (typ. 25 W total dissipation including DSP)
Two temperature sensors
Voltage sensor
Cut-off temperature preventing module overheating

QSFP-DD800

Home | Products | Data Center | Test Solutions

bottom of page